Center support bearings-how to change??
#2
RE: Center support bearings-how to change??
I'm pretty sure your talking about the carrier bearing on the driveshaft but if I'm wrong just slap me. Never done one on one of those but typically, you simply unbolt the driveshaft at the rear, unbolt the center support bearing holder, slide the driveshaft out of the tranny, figure out how it comes apart in the middle(I think it just slides apart usually) and do those steps in reverse to install.
#4
RE: Center support bearings-how to change??
A write-up?! LOL! It couldn't be easier man. I've only ever heard of like one chevy truck ever causing someguys problems and that was because crap was rusted/ceased up in place.
#6
RE: Center support bearings-how to change??
I like all of the write up's. Even if it is a simple job there is always little tricks that help out that you only learn of by doing it. I will post something after I am done.
#9
RE: Center support bearings-how to change??
ORIGINAL: Argon
it sux..
you'll need a press,torch or something to push/cut the bearing off...and a driver or press to put the new one on
it sux..
you'll need a press,torch or something to push/cut the bearing off...and a driver or press to put the new one on