BBK Throttle body
 

I bought a bbk throttle body online. I have a superchip programmer, intake, throttle body spacer, flowmaster exhaust, hollowed out maf, and forced air-induction goodman hood. I installed the throttle body and it is throwing off throttle linkage codes and it wont rev over idle. I was wondering if anyone knew if I could possibly do anything to run it temporarily until I can afford a full tune? Also I see the posts of bypassing the throttle body coolant lines? I would think I could just use a braided brass nipple and connect the two lines together? Does it actually effect heat transfer of air to the intake?