New to Forum
#1
New to Forum
Hey everyone!
Just found this forum and thought I would say Hello to all. I have a couple of old trucks, a 65 Ford stepside and a 64 Chevy C10. Love tinkering on these things.
I am new to Chevy products and will have some questions regarding this truck. I just purchased it for my father in law for Father's Day. It is pretty much original but not cherry enough to restore as such. It has a 327 4 barrel in it, but don't know much more about it than that. I know Ford motors pretty well but I would love to know more about this little small block.
Any tips for me?
Thanks,
Just found this forum and thought I would say Hello to all. I have a couple of old trucks, a 65 Ford stepside and a 64 Chevy C10. Love tinkering on these things.
I am new to Chevy products and will have some questions regarding this truck. I just purchased it for my father in law for Father's Day. It is pretty much original but not cherry enough to restore as such. It has a 327 4 barrel in it, but don't know much more about it than that. I know Ford motors pretty well but I would love to know more about this little small block.
Any tips for me?
Thanks,
#2
RE: New to Forum
Sounds cool! I just turned down a '69 GMC pickup with a straight 6 because of the same problem. Not taken care of enough to restore. Would have made a good fixer upper beat in the woods truck though!
Anyway the good news is there are plenty of GM gurus on here; the bad news is there aren't too many on here interested in Furds.
Anyway the good news is there are plenty of GM gurus on here; the bad news is there aren't too many on here interested in Furds.
Thread
Thread Starter
Forum
Replies
Last Post