hi people need help removing plactic cupler for heater hose. bumped it and it broke very easy. here is a pic of it

[IMG]local://upfiles/5190/5A9FA09D339348ED807F83E101A1A129.jpg[/IMG]

[IMG]local://upfiles/5190/E0C59B65D80746A483F2B4BBF9DF0C3F.jpg[/IMG]

 

You need the part or you need help removing it? Whats the question? lol

 

need help removing it.

 

ok guys figured it out went to dealership and got new part and asked them. they said the tool for cost more than the part so waste of money just cut it off.

 

No!!!! Just hang on.... mutantz71 did the same thing to his... I'll get him to post on how we fixed it...

 

Its a common problem i think, but if you wanna change it you have to pull the heater core F**k that i just got a heater hose that was slightly bigger so itll slide over the remaining piece clamp it on with regular clamp run it back to the water pump ive had it like that for about a year and half works just fine.

 

it does take a special tool to remove the 2 connectors..its cheap,but i dunno where to tell youn to get 1...otcmakes em...you can cut it off,but be careful of your core tubes!