96 12v boost problem
#1
96 12v boost problem
Hi all,
Today I was checking to see if my waste gate was working properly(truck feeling low on power) I applied about 15 psi of regulated pressure and it didn't move, upon dissasembly it had a busted diaphram.Checked operation of waste gate valve and it moves freely.So i removed the brass 90 barb fitting on turbo housing to check boost with guage and held waste gate closed started engine and no boost,increased rpms and nothing, took soapy water around looking for leaks spraying around intercooler and piping connected to it.Is there anything else I could try,or any suggestions on problem any help would be greatly appreciated.
Thanks
Dave
Today I was checking to see if my waste gate was working properly(truck feeling low on power) I applied about 15 psi of regulated pressure and it didn't move, upon dissasembly it had a busted diaphram.Checked operation of waste gate valve and it moves freely.So i removed the brass 90 barb fitting on turbo housing to check boost with guage and held waste gate closed started engine and no boost,increased rpms and nothing, took soapy water around looking for leaks spraying around intercooler and piping connected to it.Is there anything else I could try,or any suggestions on problem any help would be greatly appreciated.
Thanks
Dave
Thread
Thread Starter
Forum
Replies
Last Post
TuckerMaxx
Chevy Silverado/ GMC Sierra Forum
2
03-15-2011 07:40 AM