Well I'm about to get my drivers license so I'm going to fix my grandpaws old F250. He got it at a state auction for $175 not running, put a starter on it and drove it home. It was parked in 1999 when he died, I pulled it out last week and started going over it. It needs some work, it has some rust and dents (was a work truck) it needs a driver side front fender and a bed. The motor is shot, (no compression) I have a new 302 in my dads old truck, it has less than 2000 miles on it. I also have a Holly carb and Edelbrock intake, all I need is a set of headers.
Before I started cuting;

2 hours later;

After I pulled it out;


One of my cousins gave me a bumper


So what do yall think?

 

i like it

 

Know anywhere to get some cheap headers? Best price I found is $147 for Flowtech headers.

 

Flow-tech is the way to go bud. And that's a very good price for them.

 

Have you tried e bay ?

 

craigslist.org

ilovebodykits.com

northernautoparts.com

discountautoparts.com

All these are good sites as well.

 

true but I have always been partial to e bay

 

Auto Zone has stainless Flowtechs for $180, I'm probably going to get them.
So far I got two new front fenders and two new doors, $200. A new front driveshaft. Costs over $300 from LMC, I got it for $15. The bed I'm going to get is $150.

 

keep up the good work !!

 

Motor is ready to go in. Front fenders, hood, radiator support, rear half of the frame, and drivers door are all painted. Rear axel seals have been changed. I have to clean under the hood, prep the cab for paint, change the gas tank, change the driveshaft, and paint the other door before the weekend.