Input drive shaft slack for manuall transmission
!["F"irst "O"n "R"ace "D"ay man's Avatar](data:image/svg+xml;utf8,<svg xmlns='http://www.w3.org/2000/svg' viewBox='0 0 50 50'><circle class='avatar-circle-default' fill='%2370589a' cx='25px' cy='25px' r='20px'></circle><text class='avatar-text-default' x='49%' y='53%' fill='white' text-anchor='middle' alignment-baseline='middle'>"</text></svg>)
Thread Starter
|
Junior Member
Joined: Mar 2009
Posts: 1
From: Covington, louisiana
Input drive shaft slack for manuall transmission
I have a 96' Ranger 2wd, 4.0 V6 extended cab, i just had a clutch failure and after dropping the tranny ther is a little slop in the input shaft for the tranny, does any one know if there is a bearing that is worn out behind the master cyinder or if it is something else? 
Any info is appreciated, this danger ranger needs to be back on the road again, before the service truck gives out from being wore out from 300,000 miles being on it.
but yet Ford is First On Race Day always
Any info is appreciated, this danger ranger needs to be back on the road again, before the service truck gives out from being wore out from 300,000 miles being on it.
but yet Ford is First On Race Day always
Thread
Thread Starter
Forum
Replies
Last Post
bzmnktm
Chevy Silverado/ GMC Sierra Forum
2
Mar 10, 2011 07:44 PM
mic_in_chevy
Chevy Silverado/ GMC Sierra Forum
2
Mar 9, 2008 08:48 AM
Grizzly660
Chevy Silverado/ GMC Sierra Forum
0
Dec 15, 2005 05:28 PM
